Gengshuang hand weapon _Xbox handle transformation game action guidelines

2013-07-11 15:07:14

If you have an Xbox handle, hoping that it can also be used on a computer do? Then and I together, through a simple transformation process can get it.

This is to transform the handle and a USB cable, after which it unrecognizable to see two kinds of interfaces are different, in fact they are very similar to the pin definitions.

Select the cable has two considerations: First, since the handle to give painting, playing with the computer chassis color color harmony, so do not follow the Xbox controller on the green cable. Secondly, the cable length is 1.5 meters more appropriate. To remove the real transformation of the original handle, remove the six screws.

Cover easily removed, the internal structure of the handle unfolded: two large joystick and two sets of rubber gasket is fixed to the PCB, and the cross keys and other buttons are removable.

Then began removing PCB circuit board, which must first remove four Ying golden small screws and vibration of the motor power supply interface.

PCB board is removed, the bottom of the handle can be removed the other half shell. It should be noted that the left and right sides of the vibration motor is actually not the same, do not be confused. The left is the low frequency vibration motor: on the right is high frequency vibration motors. As long as computer games support vibration function, Timor Kera motor can work, so that we get in the game was renamed interactive experience, so do not be removed vibration motor

When I first saw the cable when the roots, mistaking where the white port is a pluggable design. In fact, some of these families is just kind of plastic protection, Tuen cable ends are soldered on PCB circuit board, so it is best to cut the cable Xbox controller's wife can be seen, I use a new USB interface cable instead of × box handle cable and insert it in the card line mouth. This is the root with a USB cable outer layer of metal shielding protection so than × box handle cable slightly rough, and the card was in the cable line lubricate the mouth to insert.

Then start the connection wires, USB cable, each conductor has a special color. In the Xbox controller also follow a similar definition of standards. Just cut them to set aside a short USB cable used to weld. Peel the skin leads them correspond with the USB cable tightened if the best conditions solder a few clicks, it will be more firmly

Observe carefully you will find: × box handle and "Burgundy yellow wires. This is just an additional signal line is used to detect whether the handle inserted into the Xbox console, you can ignore all the parts installed, even if the initial completion of renovation

Before using the computer, you also need to www. codeunderground. com free download the appropriate drivers, the perfect support for most mainstream games. If the handle successful transformation, the system will find the "unknown device". According to the system prompt, you can easily install the driver. After the driver installed under Control Panel to find "game controllers" application, click the "Properties" button to enter the setup program handles. This needs to Axis Deadzone (axis dead zone) is set to 0%; would Button Sensitivity (button sensitivity) is set to 50%. In the "Force Phreak (tm)" li testable rumble feature. If the two right and left vibration motors are set to 255, then 100% then they will output the function

LoginName:
Password:
Verification: